Advertisement
64LHP4000
Remote Control Unit Functions
2
1
5
2
7
4
REMOTE CONTROL UNIT SETTING BUTTONS
1
1 Remote control mode select buttons
Use to switch the remote control unit modes.
• This remote control can be used to operate the Rear Projection
TV, a DTV Decoder, and a cable TV box.
• By selecting one of the three mode select buttons, this remote
control can be used to adjust common functions, such as channel
selection, for that device.
2 Light button
When this button is pressed, some buttons on the remote control
unit will light. The lighting will turn off if no operations are performed
within about six seconds.
This button is used for performing operations in dark places.
REAR PROJECTION TV (MONITOR TV)
CONTROL BUTTONS
1 POWER button
9
Turns the power of the Rear Projection TV on and off.
2 Input button (TV, INPUT 1 to INPUT 4)
8
Press the button to select the source you wish to watch. The screen
will display your selection.
3 VIEW MODE button
Press to select the VIEW MODE.
6
4 ANT-A/B button
Press to switch between ANTENNA-A and ANTENNA-B when you
wish to watch TV.
5 Direct channel selection buttons
Press the button (or buttons) that corresponds to the channel that
you wish to watch.
6 CH (channel)
Press plus
or minus
Only the preset channels can be tuned in using these buttons.
7 MUTE button
3
Press to temporarily turn off the sound. Press again to return to the
previous volume level.
8 Cursor/ENTER buttons (
,
,
,
: Press to select or adjust items on the menu
ENTER:
9 FAVORITES buttons
These buttons call up the channels that have been assigned to
them.
6
,
button
to tune in a higher or lower channel.
,
,
,
screen.
Press to activate the selected function.
,
)
Advertisement
