Lionel VISION Owner's Manual page 20

LEGACY and Command Control Remote
Operations
Loading scenarios 1, 2, and 3 continued
Load Step 2: Produce
You must go through the first loading scene (adding ice) before you can add produce. Once ice is
loaded move the VISION Reefer to the next desired location on your layout. It's OK to stop and start
more than once on the way to the produce warehouse.
Follow the instructions for Load Step 1, but this time the dialog will include orders to load produce.
Again, a tap of the load button plays a short scene, pressing and holding extended the loading
sequence as long as you like. But the foreman will complain if it takes too long! Repeat the produce
loading scene if you like, or move the train towards your final destination.
Load Step 3: Re-Icing
En-route to your destination you may want to add additional ice to replace what melted in transit.
The re-icing scene is triggered in the same way as the previous two scenes. Load Step 3 is the final
loading sequence and will repeat each time you trigger it, even if you move your VISION Reefer
between triggers. In order to reset the loading sequence back to Load Step 1, the car must be unloaded
(see next section). A reset command or removing track power will also reset the load sequence to the
first step.
20