Adjusting The Volume From Your Cab-1 Or Cab-1L Remote; Shut Down And Start Up Commands - Lionel VISION Owner's Manual

LEGACY and Command Control Remote
Operations
Adjusting the volume from your CAB-1L, or CAB-1 remote
To adjust only the levels of the background sounds in CAB-1 or CAB-1L mode, such as rail clatter,
bump and grind sounds:
1. Press ENG and enter the reefer ID.
2. Press AUX1 first, then press the volume up or down keys on your remote.
In this case, a metallic clank sound will confirm the background or "blend" sound volume is being
adjusted. Again, this confirming sound will not be heard when the background/blend sound volume
reaches its minimum or maximum level.
Note!
To adjust the overall volume of the reefer, follow the instructions above except do not
press AUX1. Only press the volume up or down buttons.
Note!
Be aware that if your Min/Max switch is in the Min position, adjusting the master volume
or blend volume from your remote will have essentially the same result.

Shut down and Start up commands

L
ike a LEGACY locomotive, you can shut down the VISION Reefer to turn off the sounds. Refer to
pages 8 through 11 for LEGACY and 13-15 for TMCC.
To restart after shut down:
As illustrated in Figure 1, press ENG and 1 (if you have not already programmed
the reefer a different ID #) to address the reefer car with your LEGACY CAB-2,
CAB-1L, or CAB-1 Remote Controller.
Figure 4. LEGACY engine selection Figure 5. LEGACY start-up
18