Connecting The Power Cord; Selecting An Am Interval Spacing; Changing The Color System - JVC GNT0066-001A Instructions Manual

Supplied composite video cord
Main unit
COMPONENT VIDEO
Y P P
B R
S-VIDEO
VIDEO OUT
You can enjoy pictures of better quality using the
following cord instead of the supplied video cord.
Connecting by using the S-Video cord
S-Video cord (not
Main unit
supplied)
COMPONENT VIDEO
Y P P
B R
S-VIDEO
VIDEO OUT
Connecting by using the component video
cord
You can enjoy better quality pictures than when
using the S-Video cord.
TV
Green
COMPONENT
VIDEO
Y P P
B R
VIDEO OUT
Main unit
CAUTION
Use either the S-Video cord or the component
video cord. If both cords are used, pictures may
not be played properly.
NOTE
• In order to enjoy pictures with Progressive mode
(page 26), the TV is required to have Progressive
video input.
• If the component video input jacks of your TV are
BNC type, use a plug adapter (not supplied) to
convert the plugs.
TV
TV
Component video cord
(not supplied)
Blue
Red
S-VIDEO

Connecting the power cord

AC outlet
Supplied power cord
• Connect the power cord after all other
connections are complete.
• The STANDBY lamp (on the front panel) will be
lit.
Selecting an AM interval
spacing
You can change the AM interval spacing.
Some countries space AM stations 9 kHz apart,
and some countries use 10 kHz spacing.
• Before doing the following procedure, select
AM as source, then turn off the unit.
• Use the buttons on the main unit.
To set the AM tuner to the 10 kHz spacing:
While holding ¢, press
STANDBY/ON
To set the AM tuner to the 9 kHz spacing:
While holding 4, press
STANDBY/ON
Changing the color
system
You can select the video output to match it to the
color system of your TV (PAL or NTSC).
1
Press and hold VFP for 4 seconds while the
system is turned off (on standby).
2
Press cursor 2/3 to select the video output.
Press ENTER to set the video output.
Getting started
Main unit
.
.
11