Remote Control Battery Information - BONFEU BonFlame Linear Optiflame Assembly Instructions Manual

INSTRUCTION FOR REMOTE CONTROLLER
AND SWITCH PANEL
ELECTRIC
NOTICE
i
When the heater is first turned on, a slight odor may be present. This is normal and should not occur again
unless the heater is not used for a long period of time.
NOTICE
To improve operation, aim the remote control at the front of the fireplace. DO NOT press the buttons too
quickly. Give the unit time to respond to each command.

REMOTE CONTROL BATTERY INFORMATION

This remote control uses two AAA batteries (Not included).
Instructions for battery installation are on the Remote Control battery compartment.
WARNING
!
NEVER dispose of batteries in fire. Failure to observe this precaution may result in an explosion.
Dispose of batteries at your local hazardous material processing center.
TEMPERATURE LIMITING CONTROL
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature,
the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2. Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes.
3. Inspect the fireplace to make sure no vents are blocked or clogged with dust or lint. If they are,
use a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a professional.
Manual_Electric_2021-UK-4.indd 11 Manual_Electric_2021-UK-4.indd 11
UK
23-05-2021 17:13 23-05-2021 17:13