Table of Contents
Advertisement
Instruction for Remote Controller and Switch Panel
ELECTRIC
CONTROL PANEL /
REMOTE CONTROL OPERATION
Control Panel / Remote Control Operation
Control panel POWER switch must be ON
(Control panel POWER switch must be ON to use remote control.)
to use remote control.
The touch display panel is shown by LED's on the front bottom right of the appliance.
T T h h e e t t o o u u c c h h d d i i s s p p l l a a y y p p a a n n e e l l i i s s s s h h o o w w n n b b y y L L E E D D ' ' s s o o n n t t h h e e f f r r o o n n t t b b o o t t t t o o m m r r i i g g h h t t o o f f t t h h e e a a p p p p l l i i a a n n c c e e . . T T h h e e
The LED's will appear on the bottom of the fireplace control panel.
L L E E D D ' ' s s w w i i l l l l a a p p p p e e a a r r o o n n t t h h e e b b o o t t t t o o m m o o f f t t h h e e f f i i r r e e p p l l a a c c e e c c o o n n t t r r o o l l p p a a n n e e l l . .
POWER
FLAME
Top light
HEATER
TIMER
TEMPERATURE
WARNING: Do not move or remove the mesh trim panel, when the appliance is plugged in
and operating. This will cause the remote control and touch panel to no longer function.
WARNING
!
Do not move or remove the mesh trim panel, when the appliance is plugged in and operating.
When the heater is first turned on, a slight odor may be present. This is normal and
NOTICE
This will cause the remote control and touch panel to no longer function.
should not occur again unless the heater is not used for a long period of time.
To improve operation, aim the remote control at the front of the fireplace. DO NOT
NOTICE
press the buttons too quickly. Give the unit time to respond to each command.
Remote Control Battery Information
This remote control uses two AAA batteries
•
Manual_Electric_2021-UK-4.indd 10
Manual_Electric_2021-UK-4.indd 10
INSTRUCTION FOR REMOTE CONTROLLER
AND SWITCH PANEL
Turns the appliance ON/OFF.
Controls Flame colors.
3 Settings: (L1 yellow-L2 blue-L3 purple-cycle)
Controls Top light colors.
3 colors: (F0 OFF-F1 yellow-F2 blue-F3 purple-cycle)
Controls the Heater.
Press button to initiate the heater.
(OFF) no heater or blower.
(LO), heater blows warm air (750W)
(HI), heater blows hot air (1500W)
NOTE: Heater functions cycle from OFF-LO-HI
Controls the Timer.
9 Settings: (1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h,9h) Press button
until reach desired setting.
1. Press once: Control panel indicator becomes active.
2. Press again until desired setting is reached. Digital display
(Not
included).
Control Switch Panel
Temperature setting
Timer Setting
Top light setting
shows setting circles as below.
Display Value
1 2
3
4 5
C 22 24 26 28 30 37
°
Temperature
F 71 75 78 82 86 99
°
NOTE: Press the button for 15 seconds, the temperature
setting will switch from °C to °F. Same way from °F to °C.
Power ON/OFF
Heat setting
Flame setting
.
6
UK
23-05-2021 17:13
23-05-2021 17:13
Advertisement
Table of Contents
