Mackie PPM Series Manual

Connecting powered speakers

Hide thumbs Also See for PPM Series:

KNOWLEDGE BASE

The PPM Series mixers give you options for hooking up Powered Speakers OR passive speakers

and PPM1008, and the top of the PPM1012.

Some examples of Powered Speakers are the Mackie SRM series, HD series, and Thump series.

For best results, use balanced cables when connecting your Powered Speakers.

Important Note:

Never plug a Passive Speaker into the Line level outputs of your PPM Mixer, as

this output is extremely low level and requires a power amp. Please see our document on how to

connect Passive speakers.

Connect your Main Left and Right Powered Speakers to the MAIN LEFT and MAIN RIGHT jacks on the

front of the PPM. Connect a Subwoofer to the MAIN SUB jack.

The controls for these outputs are highlighted below.

16220 Wood-Red Rd NE •Woodinville, WA•98072•USA

Phone: 425.487.4333 • Toll-free: 800.898.3211

Fax: 425.487.4337 Email: Techmail@loudtechinc.com

www.mackie.com

Connecting Powered Speakers

http://www.mackie.com/ppmseries

Table of Contents

Do you have a question about the PPM Series and is the answer not in the manual?

Page 1 Connecting Powered Speakers The PPM Series mixers give you options for hooking up Powered Speakers OR passive speakers powered by an external Power Amp via the line-level outputs located on the front of the PPM608 and PPM1008, and the top of the PPM1012.
Page 2 KNOWLEDGE BASE http://www.mackie.com/ppmseries Connecting Powered Speakers Monitor 1 Connect your Powered Speaker or Speakers to the MON 1 SEND jack on the front of the PPM. The controls for this output are highlighted below. Monitor 2 Connect your Powered Speaker or Speakers to the FX/MON 2 SEND jack on the front of the PPM.