Advertisement
Maintenance and Servicing
Procedures not specifically explained in this manual
must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Power Switch/Trigger is in the off-position and unplug the tool
from its electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs,
have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. BEFORE EACH USE, inspect the general
condition of the tool. Check for:
• leaking, swollen, or cracked battery pack,
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFTER USE, clean external surfaces of
the appliance with clean, moist cloth.
Cleaning Nozzle
1. If Nozzle becomes plugged, remove Battery
Pack and make sure tool is in Off Position.
2. Unscrew and remove Nozzle from Spray
Wand. Push a small wire through the cross
holes to clear any debris. If necessary, rinse
the cross holes and Nozzle with clean water.
Page 8
For technical questions, please call 1-888-866-5797.
3. AFTER EVERY USE, clean the Sprayer:
a. Reinstall Battery Pack and Flush
with water until Tank is empty.
b. Clean Nozzle and Tank Strainer.
c. Allow to air-dry with the Tank open.
d. After dry, replace Strainer and Tank Lid.
Note: Do not use flammable cleaners or
abrasive cleaners when cleaning tool.
4. Disconnect battery pack and store battery pack,
charger, and tool in dry, indoor area out of
reach of children and away from metal objects
(i.e., paperclips, coins) to prevent shorting.
5. "Li-Ion battery must be recycled
or disposed of properly.
3. Wipe Nozzle and cross holes with a
clear dry cloth and reinstall Nozzle.
Item 58671
Advertisement
