Panasonic NI-GT500 Operating Instructions Manual page 5

CAUTION
Do not use steam while the iron is rested on the
power base.
- Doing so may cause scalds.
Do not tilt or move the power base violently
back and forth.
- Doing so may cause water leakage.
Do not touch the hot surface (such as the
surface of the soleplate, any side of the iron, the
corded hose, the heat-insulation pad and the hot
area around it) during use.
- Doing so may cause scalds.
• Do not place your hands,
feet, etc. under the
ironing board.
• Do not place the iron on
your hand, knee or any
other part of the body.
• Do not use steam when
the iron is partially
sticking out from the
ironing board.
08
NI-GT500 series-01 EN.indd 6
Do not touch the steam during use.
• Do not aim the steam towards your
hand, knee, or any other part of the
body.
• Do not iron clothes that you are
wearing.
- Doing so may cause scalds.
Do not place the power base
sidelong.
- Doing so may cause water
leakage, and then damage
floors and carpets.
Do not put the iron on a carpet or
the floor.
- Doing so may damage the
product, carpet or floor.
Make sure the product has fully cooled down
before opening the bottom knob.
- Failure to do so may cause scalds.
CAUTION
Disconnect the power plug by holding the power
plug instead of pulling the power cord.
- Failure to do so may break the power cord, and
may cause burns, electric shock, or fire due to a
short circuit.
Care should be taken when using the product.
- Steam emission may cause burns.
Use the product only for its intended purpose,
for ironing fabrics.
- Failure to do so may cause injury.
When using with following fabric, test on an
inconspicuous area, or place a cloth over the
fabric to prevent the fabric from marking.
• Expensive or specially processed fabrics (velvet,
acrylic, nylon, cashmere, etc.)
• Fabrics that are labeled as low heat or "medium
" "
heat", or dark colored fabrics.
- Failure to do so may cause damage fabric.
Always unplug the power plug during filling,
emptying, cleaning and not in use.
- Failure to do so may cause electric shock or fire
due to electrical leakage resulting from insulation
deterioration.
When ironing wet clothes, please use dry
ironing.
- Failure to do so may cause scalds due to hot
water splashes from the main body.
Place the iron correctly as instructed after use.
- Failure to do so may cause the product to fall over,
thus resulting in injury or scalds.
09
2021/8/20 14:34:23