LG Studio MHES173 Series Installation Manual page 9

2 ft
1/4" x 10" 90° elbow
a
Wall cap (1ea)
b
Straight duct (8 ft)
Total length
For 6" round systems
2 ft
Transition (1ea)
90°elbows (2ea)
b
Wall cap (1ea)
c
Straight duct (8 ft)
Total length
Step 3: Prepare the Venting Blower
Your microwave oven is shipped with the blower
assembled for room venting. You need to adjust
the blower if you want wall-venting or roof-venting
installation.
WARNING
• Electric shock hazard! Unplug unit before
working on it.
• Do not pull or stretch the blower wiring. Pulling
and stretching the blower wiring could result in
electric shock.
• To avoid risk of property damage, unplug the
microwave oven or disconnect the power at the
source by removing the fuse or throwing the
circuit breaker.
• To avoid risk of personal injury, wear protective
gloves when handling the mounting plate.
Installation
1
Remove any shipping materials and parts
from inside the microwave oven. Set them
aside for later use.
2
Cover the countertop or cooktop with a thick,
protective covering to protect it from damage
and dirt. If your range has cooktop controls in
6 ft
= 25 ft
(1ea)
= 40 ft
= 8 ft
= 73 ft
6 ft
= 5 ft
= 20 ft
= 40 ft
= 8 ft
= 73 ft
the front, unplug the range before covering
the cooktop to prevent risk of fire and
damage if the knobs are accidentally activated
while installing the OTR.
Blanket, cardboard or other covering
a
NOTE
• If you have a free-standing range, disconnect it,
move it onto a piece of cardboard or hardboard
and pull it away from the wall, so that you can
get closer to the upper cabinet and back wall for
easier measuring and drilling.
3
Remove the mounting plate screws
the mounting plate
4
This plate will be used as the rear mounting
plate. (It will be used to locate and mark the
mounting holes on the rear wall.)
5
Locate the exhaust adapter, grease filters and
hardware packet.
6
At this point, remove any adhesive tape (if
there is any), on the exhaust adapter, the
grease filters and the power supply cord.
Room-Venting (Recirculating)
Installation
This oven is shipped assembled for room-venting.
Wall-Venting Installation
1
Remove one cover plate mounting screw
and the cover plate
blower plate mounting screw(s)
blower plate . Remove the cover plate
d
INSTALLATION
from
a
as shown and discard.
b
a
. Remove one or several
b
and the
c
e
9