LG Studio MHES173 Series Installation Manual page 14

14 INSTALLATION
Step 6: Attach the Oven to the Wall
WARNING
• To avoid risk of personal injury or property
damage, you will need two people to install this
microwave oven.
1
Carefully lift microwave oven and hang it on
the support tabs at the bottom of the
mounting plate. Reaching through the upper
cabinet, thread the power supply cord
through the power supply cord hole
bottom of the upper cabinet.
2
Rotate the microwave oven upward so the top
of the oven is against the bottom of the upper
cabinet or cabinet frame.
3
Then insert a bolt down through each hole
in the upper cabinet bottom. Tighten the bolts
until the gap between the upper cabinet and
microwave oven is closed.
4
Roof venting installation: Install the ductwork
through the vent opening in the upper
cabinet. Use a caulking gun to seal the
exterior roof opening around the exhaust cap.
Damper
a
5
Use the power supply cord clamp
the power supply cord. Install the power
a
6
in the
b
a
to bundle
b
supply cord clamp to the inside of the cabinet
using a screw.
Duct
a
Grasp the filter screen with one hand holding
the ring and the other hand holding the
opposite end. Insert the end of the filter
screen without the ring into the opening and
slide towards the side of the microwave oven.
Insert the ring end of the filter screen into the
opening and slide the entire screen towards
the center of the microwave until the screen is
securely in position. Repeat for the other filter
screen.
2
1
2
3
1