LG Studio MHES173 Series Installation Manual page 10

10 INSTALLATION
and one or two blower unit mounting screw(s)
.
i
Blower unit
f
Knockouts
g
Back plate
h
2
Carefully lift the blower unit out of the
microwave oven.
3
Use side cutters or tin snips to cut out and
remove the knockouts
. Be careful not to distort the back plate.
a
Discard the knockouts.
4
To avoid pinching the blower wire, make sure
that it is channeled underneath and between
the two exhaust ports when they are rotated.
from the back plate
b
5
Rotate and reinstall the blower unit
the exhaust ports
cabinet and are aligned with the rear
knockouts. When you insert the blower unit,
the blower wire
c
6
Attach the blower plate
oven so the blow unit exhaust ports
blower plate opening are aligned. Attach one
or two blower unit mounting screw(s)
then one or several blower plate mounting
screw(s) . Attach the cover plate
a
blower plate with a screw
Blower unit
b
Back plate
e
7
Insert the tabs on each side of the damper
into the holes at the inside rear of the
adapter. Attach the exhaust adapter
back plate wall side. Push in securely until it is
past the top locking tabs
locking tabs . Make sure that the damper
c
hinge is at the top and that the damper
swings freely.
Damper (hinge side up)
b
Guides
c
Slide exhaust adapter into guides on rear
e
panel.
so that
a
face the rear of the
b
must be routed as shown.
to the microwave
d
and
c
f
on the
g
.
h
to the
a
and in the lower
c
and