LG Studio MHES173 Series Installation Manual page 6

6 INSTALLATION
Parts
Included Parts
NOTE
• Depending on your ventilation requirements,
you may not use all of these parts.
Power cord clamp bushing (1ea): for the cord
a
hole in a metal upper cabinet
1/4" x 2" lag screw (2ea): for wall stud holes
b
1/4" x 3" toggle bolts (2ea): for drywall holes
c
Spring toggle heads (2ea): for the toggle bolts
d
1/4" x 3" bolts (2ea): for securing to the upper
e
cabinet
Tapping screws (2ea): for attaching the damper
f
duct connector
Power cord clamp (1ea) and dark-colored
g
mounting screw (1ea): to hold the power cord
Back-draft damper: 2 pieces must be
h
assembled as shown. (for roof venting or wall
venting installation, not for room venting
installation)
Upper cabinet template (1ea)
i
Rear wall template (1ea)
j
NOTE
• You need to install at least two lag screws into a
2" x 4" stud and four anchor bolts into the wall.
The mounting area must meet the 150 lb. weight
requirement.
Tools and Materials
You will need the following tools and materials for
the installation:
Phillips screwdriver (for the screws)
a
Flat blade screwdriver (for the toggle bolts)
b
Small side cutters (nipper) or tin snips
c
Measuring tape (metal preferred)
d
Stud finder
e
Plumb line
f
Pencil
g
Clear tape (for taping the templates to the wall)
h
Saber saw (for cutting vent holes for roof or
i
wall venting)
Electric drill
j
3/8" and 3/4" wood drill bits
k
1/2" and 3/16" drill bits
l
Keyhole saw (for the power cord hole)
m
Duct tape
n
Caulking gun and caulk
o
NOTE
• If you have brick or masonry walls, you will need
special hardware and tools.