Switching input source
Please operate input source change following the procedure mentioned below.
Setting method 1
You can change input source by OSD.
1) Activate "Operation Button Guide ① " by pressing any one of operation buttons
(A–C)
.
2) Press the "MENU" button.
3) Select "INPUT SOURCE" by using the "▲" button or the "▼" button and press the
"OK" button.
Secondly, select "DisplayPort" or "DVI" on OSD "INPUT SOURCE" and press the "OK"
button.
When the monitor doesn't receive input signals from two lines (DisplayPort
Note
and DVI), even if you press the button, this function doesn't work.
Setting method 2
You can make function buttons (F1 or F2) available to switch input signal.
By doing so, you can easily switch it by using a button.
The following steps tell you how to functionalize the "F1" button.
1) Activate "Operation Button Guide ① " by pressing any one of operation buttons
(A–C)
.
2) Press the "MENU" button.
3) Select "FUNCTION" on MENU 1/2 by using the "▲" button or the "▼" button and
press the "OK" button.
Secondly, select "FUNCTION1" on OSD "FUNCTION" and press the "OK" button.
4) Select "INPUT SOURCE" on OSD "FUNCTION1" and press the "OK" button.
5) Activate "Operation Button Guide ① " by pressing any one of operation buttons
(A–C)
.
6) Select "DisplayPort" or "DVI" on OSD "INPUT SOURCE" by pressing the "F1" button
to switch input signal.
You can check the status of "INPUT" on OSD "CURRENT STATE".
Current input source
CURRENT STATE
C U R R E N T
S T A T E
L U M I N A N C E
:
A M B
L I G H T
:
C O L O R
:
I N P U T
:
C A L I B R A T I O N
S E T T I N G
C O N F I G
:
L U M I N A N C E
:
G A M M A
:
C O L O R
:
- 20 -
4 0 9
1 0 0 . 0 lx
7 5 0 0 K
( x = 0 . 3 0 0
y = 0 . 3 1 5 )
D V I
1
4 1 0
/
0 . 6
D I C O M
G S D F
7 5 0 0 K
( x = 0 . 2 9 9
y = 0 . 3 1 5 )
5 M P