Advertisement
U-UDS5000WC Drawing Table Assembly Instructions
A
6
F
4
FIG 3
1
FIG 4
Pg. 3
IMPORTANT: ASSEMBLY IS EASIER AND SAFER WITH TWO PEOPLE
F
6
2
3
E
5
4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:(313)895-0700/Fax:(313)895-0709
Email: Custservmud@aol.com • visit us at www.MartinUniversalDesign.com
STEP 3] Tilt Bracket Assembly
3
4
Lay table top onto flat carpeted or cardboard sur-
face with holes facing up (to protect from scratching
table top). Attach the Tilt Bracket End (part E) to the
table top in the position as shown in FIG 3 using [2]
each M6 x 8mm Allen Screws (part 3) per bracket.
Line up holes in bracket end with T-nuts in table
top. Secure with Allen-Wrench. See FIG 3.
Continue by adding Tilt Bracket (part F) to tilt
E
bracket end (part E) securing with [1] M6 x 12mm
Allen-Screw (part 4), [2] washers (part 6) and [1]
Nut (part 2). Tighten with Allen-Wrench to secure.
See FIG 3.
STEP 4] Assembling Top to Base
5
Attach Top to base by having one person hold the
top while the other person attaches the hinges
F
that are on the table base to the top using [2] M4
x 12mm screws (part 1) in each hinge. Tighten
with Phillips screw-driver to secure.
Attach pencil ledge to the front edge of table top
using [2] each M4 x 12mm Screws (part 1). Secure
1
with Phillips screw-driver.
Attach Tilt brackets to table base using [1] Knob
(part 5) and [1] washer (part 7). Tighten knob to
secure. Repeat with other side.
See Fig 4B.
7
H
FIG 4B
IMPORTANT:
THIS NEXT STEP NEEDS TWO PEOPLE TO
ATTACH TOP TO BASE.
Pg. 3
Advertisement
