Preparation And Unpacking; Hydro Connection Diagramm - Nemaxx PW18 Instruction Manual

3.2 PREPARATION AND UNPACKING

Open the box, unload the stove from the platform with extreme caution, and place the desired location, making
sure that it complies with the requirements.
The body, or block should always be handled exclusively by truck in an upright position. You should pay
particular attention to the door and its glass to be shielded from shocks that might compromise their integrity.
However, the handling of the products must be done with extreme caution. Unpack the stove near the area
where it will be installed.
The materials that make up the package are neither toxic nor harmful, thus do not require special disposal pro-
cesses. So, the storage, disposal or recycling is eventually complete recovery from the end user in accordance
with applicable laws.
Do not store the fireplace and coverings without their packaging.
Position the stove, in the correct position that respects faithfully as previously described above, and proceed
with the connection to the chimney.
If you connect your stove to a discharge pipe that runs through the back wall (to take in the chimney) pay
extreme caution not to force the entrance in any way.
If the flue of the stove is forced or improperly used to lift or placed into position, it will compromise beyond
repair, the operation, and manufacturer is not considered in any way responsible for such a maladroit and / or
neglect in the work, so in these conditions any Recovery operations are excluded from warranty.
3.3. HYDRAULIC CONNECTION DIAGRAM
A1 = Heating water delivery 3/4" M
A2 = Heating water return 3/4" M
C = Safe valve 3 bar -1/2" F
50
Ø
191
89
546
80
Ø
102
262
B
430
331
[ EN ● 15 ]
Version: 2.0
KEN002PW18 25.11.2019
C
197
175
A
331