Table of Contents
Advertisement
Malfunction
i-DOScannot be
pressed
High spin speed
rental is not
reached.
Program centrifugal
run does not start.
fizzing, hissing
loud.
long, growling
loudly before the start
of the washing or
softening cycle.
Short buzzing sound
after switching on
of the device.
Cause and Troubleshooting
Program progress does not allow intelligent dosing. No
solution possible.
Low spin speed is set.
Set a higher spin speed for the next wash.
▶
Anti wrinkleis activated.
Select a suitable program for the type of fabric.
▶
Unbalance control system compensates for
imbalance through reduced spin speed.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Start the programCentrifuge.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or pinched.
The unbalance detection system has interrupted the
spin cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Start the programCentrifuge.
▶
Water is flushed into the detergent drawer under
pressure.
No error - normal operating noise.
▶
Intelligent dosing system doses detergent or care
agent.
No error - normal operating noise.
▶
Intelligent dosing system performs a function test.
No error - normal operating noise.
▶
TroubleshootingNL
49
Advertisement
Table of Contents
