Carrier Performance TP-NHP Installation Instructions Manual page 19

Performance series ac / hp programmable & non-programmable control thermostat

Hide thumbs Also See for Performance TP-NHP:

Table of Contents

NOTE: Standoffs are provided as an aid when installing Equipment Control

Module on inside equipment or a solid wall.

12. Match and connect equipment wires to proper terminals of each connector

block being careful not to over tighten the screws. Correct polarity must

be observed when connecting the two wires from the Equipment Control

Module to the thermostat mounting base. If wires are connected incorrect-

ly, the Display Module will not operate. See Fig. 7, 8 and 9.

13. Snap cover over top of Equipment Control Module. See Fig. 13.

Fig. 12 − Standoff

A07227

Table of Contents

Show Quick Links

Table of Contents

Performance tp-nac Performance tp-php Performance tp-pac