Grille Removal - JBL Project EVEREST DD66000 User Manual

VI. Cut tapes at the corners of the bottom cardboard (drawing VI), slide
out the loudspeaker system toward you together with bottom endpads
(drawing VI-2).
VII. Lift the system slightly on the right and left in turn to remove bottom
endpads.
VIII. Remove the protective non-wovens.
VI
Products are shipped with round-tipped spikes on the bottom of the cabinet. If
you would like to use pin-point spikes, please refer to figure 6 on page 12, and
remove round-tipped spikes and replace them with pin-point spikes. In case,
it is hard to loosen, please use 18mm size spanner/wrench.
Four metal coasters are also provided. These are to be placed between
the foot and the floor should further protection of the floor coverings be
required.

Grille Removal

The EVEREST DD66000 is shipped with its grille on the system. You
can remove the grille in the following procedures.
Step 1: Hold the lower parts of the grille with both hands and pull it up.
Step 2: Pull the grille toward you in order to take the grille out of the
pins from the cabinet.
Step 3: Pull the grille down and remove the grille from the cabinet.
Repeat the above procedures in a reverse order in order to install the grille back
to the cabinet.
VI-2 VII VIII