Yamaha Clavinova CLP-110 Service Manual page 8

CLP-110
3. Key Cover Assembly
(Time required: about 1 min)
3-1 Remove the top board assembly. (See procedure 1)
3-2 Cover the keyboards completely with the key cover
assembly, and lift up the rear of it. (Fig.3)
3-3 Lean the key cover assembly slightly and remove
the guide pin from the guide rail. (Fig.3)
* Don't lean the key cover too much not to let the
sash F scratch the front rail.
4. End Block Assembly (L, R) (Time required:
about 3 min)
4-1 Remove the top board assembly. (See procedure 1)
4-2 Remove the key cover assembly. (See procedure 3)
4-3 Remove the two (2) screws marked [40] to remove
the angle Z. (Fig.5)
4-4 Remove the screw marked [40] for each side to
remove the panel assembly. (Fig.4)
4-5 Remove the three (3) screws marked [7] for each
side to remove the rack (L, R). (Fig.4)
4-6 Remove the screw marked [12] for each side. The
end block assembly (L, R) can then be removed.
(Fig.5)
[12]
E
End Block Assembly (L)
8
Angle Z
L
[T2f]
(Fig.5)
[T2f]: Bind Head Tapping Screw-1 3.5X12 MFZN2Y (EP030240)
[12]: Bind Head Tapping Screw-B 4.0X10 MFZN2Y (EP640130)
[40]: Bind Head Tapping Screw-1 3.5X12 MFZN2Y (EP030240)
Keycover Assembly
Rack Assembly
[40]
[7]: Bind Head Tapping Screw-1 3.5X20 MFZN2Y (EP030470)
[40]: Bind Head Tapping Screw-1 3.5X12 MFZN2Y (EP030240)
[40]
M
M
H
End Block Assembly (R)
Keycover Assembly
(Fig.3)
[7]
C
C
C
M
(Fig.4)
[12]
E
Panel
Assembly
Side Cover