Fan Connector; Ide Connectors - Intel CV700A Manual

3-2 FAN Connector

CV700A provides one CPU fan connector and one system fan connector.
CPU Fan Connector- JF2
System FAN Connector-JF1

3-3 IDE Connectors

There are two kinds of IDE connectors on this
board, 40-pin and 44-pin. Each can support up
to two IDE-inferface devices. One standard
40-pin header daisy-chain driver connector
provides as IDE1 with following pin assignment.
40 pins (2.54mm)-CN19(IDE 1)
This connector supports the provided IDE hard
disk ribbon cable. After connecting the single
plug end to motherboard, connect the two
plugs at other end to your hard disk(s). If you
install two hard disks, you must configure the
second drive as Slave mode by setting its
jumpers accordingly. Please refer to the
documentation of your hard disk for the
jumper settings.
Note: Pin20 is +5V power can use new type DOM module.
JF2
pin1
JF1
*Note : DC- in +12V by switch to DC-out voltage +12V
So DC -in need stable +12V input
Note!
PIN 20 connector +5V of
IDE 1 could provide the
power of DOM
PIN NO.
1
2
3
pin1
PIN NO. Description
1 RESET#
3 DATA7
5 DATA6
7 DATA5
9 DATA4
11 DATA3
13 DATA2
15 DATA1
17 DATA0
GROUND
19
DREQ
21
IOW#
23
25
IOR#
IORDY
27
DACK#
29
IRQ14
31
33 SA 1
35 SA 0
37
HD CS0#
39
HD LED
22
Description
FAN Control ON/OFF
+12V
FAN speed Sensor
PIN NO. Description
2 GROUND
4 DATA8
6 DATA9
8 DATA10
10 DATA11
12 DATA12
14 DATA13
16 DATA14
18 DATA15
+5V
20
GROUND
22
24 GROUND
26 GROUND
28
PULL DOWN
GROUND
30
32
NC
34 ATA 33/66/100
CABLE SELECT
36
SA 2
HD CS1#
38
40
GROUND