Advertisement
1. Carriage bolts (3/8 x 1-1/4
inches)
2. Frame (48, 52 and 60 inch
machines)
3. Cradle bracket
4. Flange nut (3/8 inch)
5. Frame (72 inch machines) 10. Correct hole for 60 and 72
4
Installing the Z Stand
Parts needed for this procedure:
1
Pivot pin
1
Outer tube
1
Foot
2
Clevis pin
2
Hairpin cotter pin
2
Thrust washer
1
Lynch pin
Procedure
1. Install the pivot pin to the outer tube with a clevis pin
and hairpin cotter pin (Figure 5).
2. Place the foot part of stand into the outer tube. Align
holes and secure with a clevis pin and hair pin cotter
(Figure 5).
Figure 4
6. Lanyard
7. Nut (1/4 inch)
8. Bolt (1/4 x 3/4 inches)
9. Correct hole for 48 and 52
inch mowers
inch mowers
1. Clevis pin
2. Pivot pin
3. Outer tube
3. Place a thrust washer onto the pivot pin (Figure 6).
4. Insert the pivot pin into the Z Stand hub.
Note: When inserting the pivot pin, make sure the
position of slot in tube is as shown in and make sure
the chamfer is facing forward (Figure 6).
5. Place a thrust washer onto the pivot pin and secure it
with a lynch pin (Figure 6).
1. Lynch pin
2. Thrust washer
3. Hub assembly
5
Figure 5
4. Hairpin cotter pin
5. Foot
Figure 6
4. Z Stand assembly
5. Topview of outer tube and
chamfer facing forward
Advertisement
