Advertisement
Figure 2
1. Carriage bolt (3/8 x 1-1/4
inches)
2. Z Stand hub (48,52 and
60 inch mowers)
3. Right side of machine
4. Flange nut (3/8 inch)
Figure 3
72 inch hub only
1. Z Stand hub installed (72
inch mowers)
2. Angle bracket (72 inch
mowers)
5. Bottom bracket (48,52 and
60 inch mowers)
6. Z Stand hub (72 inch
mowers)
7. Angle bracket
8. Bottom bracket (72 inch
mowers)
3. Right side of machine
3
Installing the Z Stand Bracket
Parts needed for this procedure:
2
Carriage bolt (3/8 x 1-1/4 inches)
2
Flange nut (3/8 inch)
1
Bolt (1/4 x 3/4 inches)
1
Locknut (1/4 inch)
1
Bracket pin
1
Lanyard
1
Cradle bracket
Procedure
Note: Ensure the grass deflector is installed in the lower
holes in the mower deck brackets.
1. Place the Z Stand cradle bracket onto the left front
frame as shown in Figure 4.
2. Install the Z Stand cradle bracket to the frame with the
cradle bracket, 2 carriage bolts (3/8 x 1-1/4 inches)
and 2 flange nuts (3/8 inch)(Figure 4).
Ensure the correct holes are used as shown in Figure 4.
3. Install the lanyard to bracket pin. Use large loop on
lanyard (Figure 4).
4. Install the lanyard with a bolt (1/4 x 3/4 inches) and
locknut (1/4 inch) (Figure 4).
4
Advertisement
