Table of Contents
Advertisement
11. Cautions
1. Application : This specification is applied to 6wire Touch Panel.
2. Warranty : TOUCH PANEL products manufactured to this specification shall be capable of meeting all
characteristics for a minimum period of 12 months the date of shipping from NAGASAKI IPC when stored or used as
specified under normal conditions within the contents of these sheets. If TOUCH PANEL products are not stored or
used as specified herein, it will be void the 12 months warranty.
3. Features
Type ：Analog Resistive Type Touch Panel
Input Mode ：Polyester Pen or Finger
Structure ：Film----- ITO Film Glass----ITO Glass
4. Characteristics
4.1 Operating Temperature Range : From –20 to 60 (Humidity 90%RH or lower, no dew condition shall be
acceptable)
4.2 Storage Temperature Range : From –30
(Humidity 90%RH or lower, no dew condition shall be acceptable)
4.3 Input Method：
(1) with Polyester Pen：
Operation and measurement with a pen must be carried out under the following trip condition：
Material：Polyester
(2) with Finger：
Operation and measurement with a finger must be carried out under the
Material：Silicon rubber (Hardness: 60º Hs)
5. Electrical Specifications
5.1 Linearity
Direction：± 1.5% or less (with calibration controller)
5.2 Insulation Resistance： 20 MO or more @ DC 25V
5.3 Chattering Time ：10 millisecond or less @ 100KO
6. Mechanical Specifications
6-1 Operating Force（with Polyester Pen SR 0.8）
According to applicable product specification Less than 150g Using a load cell with a Polyester Pen conforming to the
specifications set forth in item 4.3 (1) attached to its tip, apply a vertical load within the valid area.
Using themeasurement circuit illustrated in diagram 6-1 below, take the gauge value when the voltage value 4.5V or
greater as the pressure load value.
6-2 Surface Hardness : 2H or Higher JIS-K5400
℃
℃
℃
to 70
Tip：SR 0.8 millimeter
Item No. Item Ratings Test Methods & Condition
℃
Tip： SR 12.5 millimeter
- 6 -
Advertisement
Table of Contents
