IBM Low Power 667Mhz Panel PC PPC-1510PT User Manual page 28

Onboard FDC
Set this option to " Enabled" to enable the floppy drive controller on the motherboard. The settings are Auto (AMIBIOS
automatically determines if the floppy controller should be Enabled, or Disabled).
Onboard Serial Port 1/2/3/4
This option specifies the base I/O port address of serial port. The settings are Auto (AMIBIOS automatically determines
the correct base I/O port address), Disabled, 3F8h, 2F8h, 2E8h, or 3E8h.
Onboard Parallel Port
This option specifies the base I/O port address of the parallel port on the
motherboard. The settings are Disabled, 378h, 278h, or 3BCh. The Optimal default setting is 378h
Parallel Port Mode
This option specifies the parallel port mode. The Optimal default setting is Normal. The settings are:
Setting
Normal
Bi-Dir
EPP
ECP
SB IRQ Select
SB DMA Select
MPU-401
MPU-401 I/O Address
FM Port (388h-38Bh)
Game Port (200h-207h)
Description
The normal parallel port mode is used.
Use this setting to support bidirectional transfers on the parallel
port.
The parallel port can be used with devices that adhere to the
Enhanced Parallel Port (EPP) specification. EPP uses the
existing parallel port signals to provide asymmetric bidirectional
data transfer driven by the host device.
The parallel port can be used with devices that adhere to the
Extended Capabilities Port (ECP) specification. ECP uses the
DMA protocol to achieve data transfer rates up to 2.5 Megabits
per second. ECP provides symmetric bidirectional
communication.
5
1
Enabled
330h-333h
Enabled
Enabled
- 28 -