Panasonic ET-DFD95 Installation Instructions Manual page 13

Assembly process
[2] Place the upper frame and upper projector on the left and right frames and align the corresponding connection
holes. Fix in place using the special purpose axis, flat washer (M12), spring washer (M12) and hex nut (M12).
Upper projector
Upper frame
Right frame
[3] Raise the front handle on the upper frame and fix the upper portions of the left and right gas springs to the
upper frame using the built-in Allen hex socket bolt (M5x10 with flat washer and spring washer ). After fixing
the gas springs, lower the handle and fix the upper frame to the left and right frames using the bolt with hex
socket (M10x60), flat washer (M10), and spring washer (M10).
Front handle
(continued)
Rear view
Attach to the right frame in the same manner.
Hex nut (M10x60)
Spring washer (M10)
Flat washer (M10)
Upper frame
Gas spring (right side)
Attach the left gas spring in the same manner.
Upper projector
Special-purpose axis
Upper frame
Left frame
Flat washer (M12)
Spring washer (M12)
Hex nut (M12)
Plate bolt(M5x10)
13