Panasonic ET-DFD95 Installation Instructions Manual page 11

Dual stacking mount bracket (for dlp based projectors)

Table of Contents

Assembly process

3. Attach the gas springs to the left and right frames.

Plate bolts(M5x10)

Left frame

This bracket attaches to the upper frame.

4. Attach the upper frame to the upper projector.

(continued)

Base frame

Gas spring

[1] Attach the lower end of the gas spring unit to the left

frame using the plate bolt (M5x10) as shown on the

left.

Fix the other gas spring to the right frame in the

same manner.

Spring upper end for attachment

to the upper frame

Mark

Gas spring

Note:

The upper end of the gas spring is indicated with a

mark. Confirm this mark when attaching.

[1] Remove the four adjustment legs (when use the

projector is PT-D9510U, PT-D9510E, PT-D9610U,

or PT-D9610E, remove the handle) from the upper

DLP

Projector (See page 10.)

[2] Insert adjustment bolt (M10) and washer (A) in the

adjustment leg holes as shown below .

Washer (A)

Indented side of washer

Snap pin hole

Adjustment bolt (M10)

Spring upper end for attachment

to the upper frame

Extendible portion

Table of Contents

Chapters

Table of Contents