Table of Contents
Advertisement
<Installing the PCB UNIT/KEYBOARD>
(1) Connect the CABLE to the KYB1 PCB and lock the connector.
[NOTE] Insert it fi rmly and lock up.
CABLE
(2) Secure the KYA1/KYB1/KYC1 PCBs with 23 screws.
Press the PCBs lightly in the direction of the red arrow in the illustration below while tightening
a screw.
(3) Install eight RUBBER CONTACT.
[NOTE] Be sure to install the RUBBER CONTACT/GC at the correct location.
[NOTE] Lightly insert the tip of a rubber contact strip into the PCB fi rst, and then, press it
in using the end of a paper clip. Do not press the RUBBER CONTACT forcefully to
avoid damaging the RUBBER CONTACT.
– 24 –
CDP-130
Hide quick links:
Advertisement
Table of Contents
