Pump Belt; Cutting Blades - Husqvarna MZ25 / 968999780 Operator's Manual

Pump Belt

Replacing pump belt
Park the mower on a level surface. Engage the
parking brake.
Belt removal
1. Remove the deck belt (see Deck Belt
Removal in this section of the manual).
2. Remove clutch stop to access the belt.
3. Disconnect clutch wire.
4. Create slack in the belt by removing the
spring on the pump idler arm.
5. The belt should now be able to be removed
from the engine pulley and pump pulleys.
Belt installation
1. Wrap the belt around the pulley
2. Route the belt around the inside of the idler
pulley.
3. Wrap the belt around the engine pulley.
4. Reattach the spring on the pump idler arm.
5. Reconnect clutch wire.
6. Replace and secure clutch stop.
7. Reinstall the deck belt. (see Deck Belt
Removal in this section of the manual).

Cutting Blades

In order to attain the best mowing effect, it is important
that the blades are well sharpened and not damaged.
WARNING!
Blades are sharp. Protect your
hands with gloves and/or wrap
blades with a heavy cloth when
handling.
Bent or cracked blades or blades with large nicks
should be replaced.
Damaged blades should be replaced when hitting
obstacles that result in a breakdown. let the service
workshop decide whether the blade can be repaired/
ground or must be replaced.
Balance the blades after sharpening.
Check the blade mounts.
MAINTENANCE
1. Electric clutch
2. Idler spring
3. Clutch stop
Pump belt removal
Check the blades
IMPORTANT INFORMATION
The sharpening of blades should be
carried out by an authorized service
workshop.
1
2
3
8054-002
8011-604
-45
English