Touch-Free Wave - Zenith HydroTap G5 User Manual

SECTION 2: Using the HydroTap

2.2 Touch-Free Wave

Controls Touch-free
sensors on the tap top,
back and sides.
Clearance requirements
Lights
RED Boiling & safety
sensors activated, water
dispensed.
BLUE Chilled sensor
activated, water dispensed.
WHITE Sparkling sensor
activated, water dispensed.
PURPLE Lock mode on (when tap is idle).
Flashing RED Sensor activated incorrectly; hand
may be too close to sensor, sensor has been
touched or covered.
WHITE / BLUE / RED Cycling 5 to 10 seconds
Filter needs replacing, CO2 warning (G5), unit
is in an error mode (refer to Command Centre
screen).
WHITE Flashing rapidly Sensors calibrating when
power is first applied to the tap. Allow 10 seconds.
8
100mm
Safety
sensor
(at back)
Dispense
sensors
100mm
806835NZ v1.05 03.22 G5 User guide
Light