Advanced Settings 2 (Wave Tap Only); System Restart - Zenith HydroTap G5 User Manual

SECTION 3: Command Centre Screen

3.5.8 Advanced settings 2 (Wave Tap only)

Wave Tap Sensor Demister Mode
Allows Control of Heating of Wave Tap
Wave Tap Lock Mode
Dual Sensors Required for Chilled/Sparkling
Wave Tap Sensor Demister Mode
• Enabled (default): activates the Wave Tap internal
heater to prevent its sensors from being affected by
condensation from steam.
• Disabled: choose this option to conserve a small amount
of power.
Wave Tap Lock Mode
• Disabled (default): Chilled or sparkling water can be
dispensed by activating the corresponding sensor.
• Enabled: in addition to the chilled or sparkling sensor,
the rear sensor must also be activated in order to
dispense chilled or sparkling water. This is useful to
prevent false activation if a highly reflective surface is
present (such as high-visibility reflective tape). Note:
Bottle fill is disabled.

3.5.9 System restart

Touch the top circle, then the bottom circle to power
down and restart the system. Use this function to reset
faults or to reset the settings access password.
28
ADVANCED SETTINGS 2 12:12 PM
806835NZ v1.05 03.22 G5 User guide