Advertisement
SECTION 2:
IGNITION
STEP 1
Ensure the appliance valve dial is
in the "OFF" position by pushing
and turning clockwise until the
dial stops.
STEP 2
Securely attach regulator (large
end of hose) to your propane
cylinder.
STEP 3
Extend hose to full length and ensure that the propane tank is as
far as safely possible from the Firebowl and place the tank in the
included stabilizer ring.
Appliance
WARNING:
TRIP HAZARD! Ensure the gas hose is placed in an area where
it is unlikely to be tripped over (such as pathways or trails) or
subject to other accidental damage.
WARNING:
The hose should not be twisted or kinked when attached to
the gas cylinder. The hose should never touch the appliance.
Ensure that the appliance is kept at a minimum distance of
0.91 m / 36 in from the gas cylinder.
Minimum
Tank Ring
0.91 m / 36 in
!
Caution:
LP Cylinder
Trip Hazard!
STEP 4
***SLOWLY*** turn cylinder valve to the FULLY open position to
avoid tripping the excess flow safety device in the gas regulator.
For more information about the excess flow safety device see
STEP 8.
STEP 5
Leak Test all connections. See section labeled "Leak Test" (page 4).
STEP 6
Your firebowl is equipped with
an auto spark ignition. Push the
knob in and slowly turn counter-
clockwise to the high position.
The ignitor will spark and ignite
the gas. Should the appliance fail
to ignite on the first try, promptly
repeat the ignition attempt within
5 seconds. If the second attempt fails to ignite the firebowl then
rotate the knob to the "off" position and wait 5 minutes before
attempting to ignite again. Turn the gas valve off at the cylinder
and inspect the ignition electrode to ensure it is free from debris.
After waiting for 5 minutes visually inspect the spark by rotating
the knob to high without turning the gas back on at the cylinder.
Ensure the spark gap is 1/8" from the burner port and has a clear
path. Once you ensure the ignitor is operating properly repeat the
ignition sequence.
WARNING:
Ensure that no parts of your body, clothing, or any other
combustible material are above the burner before, during and
after ignition.
Tank Ring
STEP 7
Once the unit is burning normally set the dial to desired flame
height.
1-888-514-1663 |
WWW.OUTLANDLIVING.COM
En-6
Advertisement
