Advertisement
V
ECTOR
13. Set the action to be performed by pressing the ( ) ( ) and
(
) button depending on function selected in instruction No. 6:
a.
OP (operating mode):
ON = Occupied, normal operation
ECO = Unoccupied, reduced operation
OFF = protective operation
b.
LP (control loop set point) LP01-LP0x*:
°C/°F
c.
AO (analogue output position) Ao01-Ao0x**:
0-100%
d.
FAN (fan control, fan speed) FAN1-FAN2:
fan speed 0-3 (FSP0-FSP3)
Auto mode (Auto)
e.
do (digital output position) do01-do0x***:
ON = enabled
OFF = disabled
➔ 4 and 5 bars indicate setting step 4 rep. 5 is executed.
* The number of available control loops depends on the used X2-controller.
** The number of available analogue outputs depends on the used X2-
controller.
*** The number of available digital outputs depends on the used X2-
controller.
14. Press (
) to complete the setting of a timed event.
15. Now you are back in menu "program selection" (instruction No. 4).
Start creating the next weekly schedules for program 2 to 12 as
required.
To go back to the previous submenu, press the (
5.3.3 Set annual time schedules (holidays)
Overview
This section describes how to set an annual holiday.
While a holiday schedule is active, the controller will be in the OFF-mode!
Other weekly schedules will still be active. It will still be possible to manually override the controller while in
holiday mode.
Up to 12 annual holidays can be programmed (Pr01 to Pr12).
Holiday schedules have priority over weekly schedules.
Requirements
Time scheduler is enabled (see chapter 5.3.1).
Procedure
1.
Press the (
) button longer than 2 seconds.
➔ SEL and the actual Date and Time are displayed alternatingly.
Doc: 70-00-0951A, Serie X2, 20211220
subjects to alteration
X2-O
PERATIONS
) button (1x).
© Vector Controls GmbH, Schweiz
www.vectorcontrols.com
M
T
ANUAL
OUCH
OP ➔
D
ISPLAY
Page 11-16
Advertisement
