Advertisement

Quick Links

FOR A SOLID GROUND
FR95
USER MANUAL IN ORIGINAL
Dok: 101536-GB 2045

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FR95 and is the answer not in the manual?

Questions and answers

Summary of Contents for swepac FR95

  • Page 1 FOR A SOLID GROUND FR95 USER MANUAL IN ORIGINAL Dok: 101536-GB 2045...
  • Page 3: Table Of Contents

    FR95 SWEPAC FR 95 is used to pack ballast under foundations, on pavements, in trenches, etc. The rounded base plate makes the machine very suitable for packing around pillars, foundations, wells, etc. In places with poor access, for example in pipe and cable trenches, the machine is easy to use.
  • Page 4: Safety Instructions

    SAFETY INSTRUCTIONS STANDARDS Noise • Before using the machine, the operator must be Measurement according to the standard EN 500-4 informed of the manufacturer’s safety instructions Rev.1: 1998, Annex C: Measurement uncertainty ± and instructions for use. 0,5dB (A) i 95% of measurements. •...
  • Page 5: Signs

    FR95 SIGNS Warning Signs Machine plate Before use, carefully read through the manual and safety regulations in order to be able to handle the machine in a proper manner. Make sure that the handbook is always available 1. Manufacturer. 2. Country of manufacture.
  • Page 6: Technical Data

    Engine oil ..SAE10W-30 Engine oil change: first oil change after 20 hours then every 100 hours of operation. Note! Vibration element for the FR95 is grease lubricated. The bearing can not be re-greased, and is permanently lubricated. This means that no oil is needed for the vibration...
  • Page 7: Technical Description

    FR95 TECHNICAL DESCRIPTION FR 95 1. Operating lever 2. Petrol engine 3. Rubber dampers 4. Vibrating element 5. Bottom plate 6. Engine plate 7. V-Belt 8. Centrifugal clutch 9. Protective silencer 10. Lifting eye...
  • Page 8: Daily Supervision

    DAILY SUPERVISION Oil/Fuel Leakage Fuel Check Check every day that the engine is not leaking oil or Check that there is fuel in the tank. Top up if fuel. If a leak is discovered, the machine may not be necessary. operated until the fault has been remedied.
  • Page 9: Before Starting

    FR95 Oil level Engine power switch Idle Full throttle Open Closed Throttle lever- Fuel cock Choke BEFORE STARTING AFTER STARTING See Daily Supervision, page 8. Switch the throttle lever to idle. Open the choke gradually. STARTING Run the engine for around 5 minutes.
  • Page 10: Dimensions

    DIMENSIONS in mm 1040...
  • Page 11: Driving Instructions

    FR95 DRIVING INSTRUCTIONS The vibrating element starts when the throttle is increased. The best packing is achieved at full engine RPM. Avoid running the engine at other RPM. The vibrating element of the machine will stop when the throttle switch is set to idling.
  • Page 12 NOTES...
  • Page 13 FR95 NOTES...
  • Page 14: Notes

    NOTES...
  • Page 15: Ec-Declaration Of Conformity

    2. Type: FR95 3. Motor power: 3.6 kW The product complies with the following directives: 2006/42/EC 2000 / 14 /EC 2004/108/EC EN 500-1 EN 500-4 Technical documentation available from: Swepac AB, Bergvägen 7 34132 Ljungby SE Tomas Johansson / Product Engineer...
  • Page 16 FOR A SOLID GROUND Bergvägen 7 | SE-341 32 Ljungby | Sweden • Tel +46 (0)372-156 00 | www.swepac.com...

Table of Contents