General Operation - Craftsman CMXEGAR500 Instruction Manual

Fig. L
29
Transporting The Grinder (Fig. L)
WARNING: To reduce the risk of injury, turn off
the grinder and disconnect it from power source
before installing and removing accessories,
adjusting and making repairs. An accidental
start-up can cause injury.
In order to conveniently carry the bench grinder from place
to place, hold the left and right side of the grinder base
for transportation.
Change Batteries (Fig. M)
WARNING: Unplug your grinder. Failure to unplug
your saw could result in accidental starting and
causing possible serious personal injury.
1. Bag "h" - Open the battery cover
2. Insert two AAA batteries into the case
the batteries, take out the old batteries and replace with
new AAA batteries. Dispose off old batteries properly.
3. Replace the battery cover
nOTE: Replace with batteries that have a rating of
1.5 volts (Number 4 series and AAA size or equivalent).
When replacing the batteries, the battery guide should
be thoroughly cleaned. Use a soft paintbrush or similar
device, to remove all sawdust and debris.
WARNING: Do not mix old and new batteries. Do not
mix alkaline, standard (carbon - zinc), or rechargeable
(nickel - cadmium) batteries.
Fig. M
31
29
30
.
31
32 . If replacing
.
31
32
OPERATION
Starting And Stopping The Grinder (Fig. N)
WARNING: To avoid injury, always keep the
plug disconnected from the power source and
switch turned OFF until the grinder is completely
assembled and adjusted properly.
The ON/OFF switch
To turn the grinder on, press the switch
position. To turn the grinder off, press the switch
"O" position.
Fig. N
30
Using The Led Light (Fig. N)
1. Press the LED light switch
"ON".
2. Press the LED light switch
"OFF".

General Operation

WARNING: Keep all bystanders a safe distance
away from the tool and not in direct line, front or
back of the grinder.
1. Your bench grinder has a medium wheel (60 grit) for
medium material removal and general purpose grinding,
and a coarse wheel (36 grit) for fast material removal.
2. To operate the bench grinder, always wear safety glasses
and turn the tool on while standing at the side and not
in front of the grinder. Allow it to reach full speed before
grinding.
3. Hold the workpiece firmly against the tool rest. Hold
very small pieces with pliers or other suitable clamps.
4. Feed the workpiece smoothly and evenly into the
grinding wheel.
5. Move the workpiece slowly and avoid jamming the
workpiece against the wheel. If the wheel tends to slow
down from excessive force, you should occasionally
release the pressure to let the wheel return to full speed.
6. The grinding wheels supplied with this unit are
designedfor different types of steel, wrought iron, and
bronze.
5 is located on the front of the grinder.
5 to the "I"
1
5
down to turn the LED light
1
1 again to turn the LED light
English
5 to the
11