FG Wilson OLYMPIAN 1001 Series Manual page 16

FAULT SYMPTOM
Alarm for Low "LOW BATTERY VOLTAGE"
Battery Voltage Alarm Lamp Illuminates
(4001 or 4001E
Series Only)
Alarm for Not in "NOT IN AUTO MODE"
Automatic Mode Alarm Lamp Illuminates
(4001E Series Only)
Alarm for "APPROACHING HIGH
Approaching High ENGINE TEMP" Alarm
Engine Temp. Lamp Illuminates
(4001E Series Only)
Alarm for "APPROACHING LOW OIL
Approaching Low PRESSURE" Alarm Lamp
Oil Pressure Illuminates
(4001E Series Only)
Alarm for Battery "BATTERY CHARGER
Charger Failure FAILURE" Alarm Lamp
(4001E Series Only) Illuminates
Alarm for Low Fuel "LOW FUEL LEVEL" Alarm
Level Lamp Illuminates
(Optional Alarm)
Alarm for Low "LOW COOLANT TEMP"
Coolant Temp. Alarm Lamp Illuminates
(Optional Alarm -
2001, 4001, 4001E
Series Only)
Generating Set Generating Set is Running
Does Not Go On but the Load is Not Being
Load Powered
(All control systems)
Generating Set Generating Set Continues
Does Not Stop Running After Being
Manually Switched Off
(All control systems)
Generating Set Generating Set Does Not
Does Not Stop Stop After Remote Start
When In Auto Mode Signal is Removed
(2001, 4001 or
4001E Series Only)
REMEDY
1. Refer to a qualified generating set technician.
1. Check Control Switch is in "AUTO".
2. Check Emergency Stop Pushbuttons are not pressed.
3. Check Circuit Breaker is on (handle up).
4. Refer to a qualified generating set technician.
1. Check engine is not overloaded.
2. Check radiator and ventilation for obstructions.
3. Refer to a qualified generating set technician.
1. Refer to a qualified generating set technician.
1. Refer to a qualified generating set technician.
1. Check fuel level in day tank. Fill as necessary.
2. Refer to a qualified generating set technician.
1. Check that the immersion heaters are switched on and are operating.
2. Refer to a qualified generating set technician.
1. Check circuit breaker is "ON" (handle up).
2. Refer to a qualified generating set technician.
1. Check Key Switch or Control Switch position, as appropriate.
2. Refer to a qualified generating set technician.
Note: On 4001 and 4001E Series Control Systems the generating set does not stop
immediately on removal of the remote start signal. Removal of this signal first initiates
the cool down period.
1. Wait 5 minutes to ensure cool down period has elapsed (4001 and 4001E Series
Control Systems only).
2. Check that generating set stops when the Emergency Stop Pushbutton is depressed
or the Control Switch is turned off.
3. Refer to a qualified generating set technician.
12