Remote Battery Installation; Operation - Fan/Remote - Hunter 20091209 Owner's Manual

remoTe baTTery InsTallaTIon

1. Turn the Remote Control over and Remove the Battery
Cover from the back by gently pressing down on the
tab and sliding down on the tab. Figure 11.
2. Insert 2 "AAA" Batteries into the battery compartment,
ensuring the positive and negative ends of the
batteries are installed correctly.
3. Slide the Battery Cover back and snap into place.

operaTIon - fan/remoTe

See Figure 12. for fan operation and Figure 13. for
remote operation.
ON/SPEED - Turns the unit on and adjust the speed of
the unit between High, medium, and low.
OSC - Sets the oscillation mode of the fan.
TIMER - Used to set the running time to 0.5 to 7.5 hours
in 30 min, 0.5 increments.
Note: The digital indicators on the fan will light up to
indicate the timer setting. 0.5 will light up for 30
minutes or 1H and 4H will light up to indicate 5
hours.
OFF - Turns the fan off.
fan IndICaTors
L M H - Indicates the current running speed of the fan.
0.5 1H 2H 4H - Shows the number of hours the timer
is set to run.
- Fan oscillates from left to right.
- Fan oscillates up and down.
- Fan oscillates in a figure 8 motion.
©2009 Hunter Fan Co. 7
figure 11.
0.5H 1H 2H 4H
L M H
ON l SPEED
OSC
TIMER
OFF
figure 12.
figure 13.
44830-01 20091209