Advertisement
right side of the trailer; the left tube assembly
must connect directly to the trailer wall.
8.
Install the trailer stops and new spacers to the
front of the tube assemblies with the cap screws
and nuts previously removed. Position the
components as shown in
Note:
Tube assemblies built prior to 2006 do
not have the trailer stop mounting holes drilled
in them. Locate and drill the holes as follows:
•
Measure in 4.5 cm (1 3/4 inches) from the
front end of each tube assembly.
•
Drill a 10.4 mm (0.41 inch) diameter hole
through the top and the bottom of the tube.
Make sure that the hole is centered on the
tube.
1. Wall stiffener
2. Wheel rod (longer)
3. Spacer
Figure
2.
4. Tube assembly
5. Tube assembly cross tube
6. Cap screw
9.
Mount a load ramp to the rear of each tube
assembly with a cap screw (3/6-16 x 2-1/2
inches), spacer, washer, and locknut
10.
Position a locking bracket onto each side of
the ramp so that they align with the underside
of the load ramps, engage with coated pins in
the load ramps, and align with the holes in the
ramp
(Figure 1
mounting holes per locking bracket.
Figure 2
7. Trailer stop
8. Kit spacer
9. Nut
2
(Figure
and
Figure
3). Use only 1 set of
1).
g217628
Advertisement
