Toro Groundsmaster 4500-D Installation Instructions Manual page 5

Figure 5
1. Flow divider
2. Pressure hose (angled
end)
3. Rear-traction tube
(forward fitting)
3. Remove the temporary cap from the hydraulic
pump.
4. Thread the straight end of the pressure hose
into the fitting in the hydraulic pump
5. Remove the temporary cap from the flow divider.
6. Thread the angled end of the pressure hose into
the fitting in the side of the flow divider
5).
7. Tighten the hose fittings to 150 to 184 N⋅m (110
to 136 ft-lb).
g027293
4. Pressure hose (straight
end)
5. Hydraulic pump
6. Forward
(Figure 5).
(Figure
Installing the Cross Tube
1. Remove the cap on the fitting of the rear-traction
manifold that you previously installed.
2. Align the tube nuts for the cross-manifold tube to
the fittings in the rear-traction manifold and the
flow divider (Figure
1. Rear-traction manifold
2. Cross-manifold tube
(rear-traction manifold
fitting)
3. Cross-manifold tube
(divider fitting)
3. Thread the tube nuts onto the fittings in the
flow divider and the rear-traction manifold, and
tighten the nuts to 51 to 63 N⋅m (37 to 47 ft-lb).
5
6).
Figure 6
4. Flow divider
5. Forward
g021296