Connection Instructions - HP L2105TM User Manual

Connection instructions

CAUTION: Before installation, please make sure to power off the display and the computer.
(Figure 3)
○
Power cord
1
○
VGA cable
2
○
Audio cable
3
○
USB cable
4
Warning:
1. Please verify the video card you are using and use an appropriate signal cable.
2. Pay attention to the PIN assignments and connection directions. Do not force to avoid bending
the pins.
6
Connect one end of the power cord into the AC power connector on
the rear of the display, and the other end to an electrical wall outlet.
Connect the signal cable:
- For analog operation use the VGA cable. Connect the VGA
signal cable to the VGA connector on the rear of the PC.
- For digital operation use the DVI-D cable. Connect the DVI-D
signal cable to the DVI connector on the rear of the monitor and
the other end to the DVI connector on the rear of the PC.
Connector one end of the audio cable to the audio-in connector on
the rear of the display, and the other end of the cable to the audio-out
jack on the PC.
Connect one end of the USB cable to the USB connector on the
display, and the other end of the USB cable to the PC.
VGA (D-sub 15 pin)