Adding Instructions At The End Of A Program - HP 12C User Manual

140 Section 10: Program Editing
Keystrokes
(RPN mode)
Ê
fs
:2?6
Keystrokes
(ALG mode)
fs
gi.006
:6
Ê
fs
:2?6

Adding Instructions at the End of a Program

To add one or more instructions at the end of the last program stored in program
memory:
1. Press fs to set the calculator to Program mode.
2. Press gi. followed by three digits that specify the last line you keyed
into program memory (that is, the highest numbered line, not necessarily the
line most recently keyed in).
3. Key in the new instruction or instructions.
File name: hp 12c pt_user's guide_English_HDPMF123E27
Printed Date: 2005/8/1
Display
006,43, 33, 008
Shows that instruction in program
line 006 has not been changed.
6,250.00
Sets calculator back to Run mode.
(Display shown assumes results
remain from last example in
preceding section.)
25.00
Copies tax rate from R
Display
Sets calculator to Program mode.
006,43, 33, 009
Sets calculator to program line
preceding that containing the
instruction to be changed.
007, 45 6
Keys new instruction into program
line 007, replacing the :2
instruction previously there.
008,43, 33, 010
Shows that instruction in program
line 008 has not been changed.
6,250.00
Sets calculator back to Run mode.
(Display shown assumes results
remain from last example in
preceding section.)
25.00
Copies tax rate from R
Page: 140 of 275
Dimension: 14.8 cm x 21 cm
into R .
2 6
into R .
2 6