Mr. Coffee ECMP2 Operating Instructions Manual page 7

The pump espresso/cappuccino maker
Hide thumbs Also See for ECMP2:
Table of Contents

Advertisement

4. Place the filter holder underneath the brew head so that the handle
positioned to the left off center. Lift the filter holder up and Insert into the
brew head and turn to the right. Make sure the filter holder is positioned
to the right of the "min" (minimum) mark. The filter holder must be
secure. See figure 2.
Brewing Espresso...
Remove the water reservoir and fill to the top of
1.
the water reservoir capacity (29 ounce capacity)
and place into the tank securely. Close Iid.
Make sure the drip grate on the drip tray is in
2.
place.
3.
Align either one or two demitasse cups under
the filter holder on the drip tray.
4.
Make sure the steam control knob is in
the OFF position, the on/off switch is OFF
and the brew switch is on the "0" OFF position.
See figure 3.
5.
Plug the power cord Into an electrical outlet.
Turn the on/off switch ON. The brew light will
illuminate to let you know the machine is on.
When the brew light shuts off, turn the brew
switch to the CUP position. The machine is now
ready to brew espresso. Espresso will begin to
flow in a few seconds. Do not remove the filter
holder at any time during the brewing
process. Do not let the pump run with an
empty water container. This can damage the
pump permanently.
When the demitasse cup(s) are about half full
(about l-1/2 ounces) press the brew switch to the OFF "0' position.
Turn the on/off switch OFF. If you are making cappuccino leave the
on/off switch ON to froth milk. (See page 8 for making cappuccino).
7. Unplug the power cord and allow the machine to cool.
8. To make additional cup(s) and after the machine has cooled down,
remove the filter holder from the brew head CAUTION: The metal
parts of the filter holder might still be very hot. Also there may be
hot water floating on the top of the filter basket. Hold the filter holder
,
steady; Using the filter retainer clip to secure the filter basket in the
filter holder, turn the filter holder upside down to empty Rinse the filter
basket and holder with cold water.
8.
Remove the water reservoir using the attached handle. Discard any
excess water.
9. Carefully remove drip tray and grate and clean any excess water or
espresso that has accumulated.
10. See for cleaning on page 10.
All manuals and user guides at all-guides.com
7
is
FIGURE 2
- -
I
,
FIGURE 3

Advertisement

Table of Contents
loading

Table of Contents