EC Declaration of Conformity The tool is intended for drilling in wood, metal and plastic. We Makita Corporation as the responsible manufac- Power supply turer declare that the following Makita machine(s): The tool should be connected only to a power supply of...
13. Prevent unintentional starting. Ensure the General Power Tool Safety Warnings switch is in the off-position before connecting to power source and/or battery pack, picking WARNING Read all safety warnings and all up or carrying the tool. Carrying power tools with instructions.
DRILL SAFETY WARNINGS FUNCTIONAL DESCRIPTION Use auxiliary handle(s), if supplied with the tool. Loss of control can cause personal injury. CAUTION: Hold power tool by insulated gripping sur- • Always be sure that the tool is switched off and unplugged faces, when performing an operation where before adjusting or checking function on the tool.
Depth gauge ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Installing side grip (auxiliary handle) CAUTION: • Always be sure that the side grip is installed securely before operation.
Drilling in metal Then tighten the grip by turning clockwise at the desired position. It may be swung 360° so as to be secured at To prevent the bit from slipping when starting a hole, make an any position. indentation with a center-punch and hammer at the point to be NOTE: drilled.
CAUTION: • These accessories or attachments are recom- mended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.