Miter Angle - Makita LS0815F Instruction Manual

SPECIFICATIONS
Model
Blade diameter
Hole diameter
Max. kerf thickness of the saw blade
Max. Miter angle
Max. Bevel angle
No load speed
Laser Type (LS0815FL / LS0815FL GBA only)
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Max. Cutting capacities (H x W) with 216 mm in diameter
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
DOUBLE INSULATION
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
When performing slide cut, first pull car-
riage fully and press down handle, then
push carriage toward the guide fence.
Do not place hand or fingers close to the
blade.
Adjust sliding fences clear of blade and
blade guard properly.
LASER RADIATION: Do not stare into
beam. Direct laser beam may injure your
eyes.
For all countries other than
European countries
For European countries

Miter angle

0°
45°
60° (right)
LS0815F / LS0815FL
Red Laser 650 nm, < 1mW (Laser Class 2)
755 mm x 450 mm x 488 mm
45° (left)
50 mm x 305 mm
50 mm x 215 mm
-
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of the European Directive,
on Waste Electric and Electronic
Equipment and its implementation in
accordance with national law, electric
equipment that have reached the end of
their life must be collected separately and
returned to an environmentally compatible
recycling facility.
Intended use
The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-3-9:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
2 ENGLISH
LS0815FL GBA
216 mm
25.4 mm or 30 mm
(country specific)
30 mm
2.8 mm
Right 60° Left 50°
Right 5° Left 48°
-1
5,000 min
15.5 kg
/II
Bevel angle
5° (right)
60 mm x 305 mm 65 mm x 305 mm
- 65 mm x 215 mm
- 65 mm x 150 mm
) : 89 dB(A)
pA
) : 100 dB (A)
WA
0°