Sealing Bar; Lid Latch Assembly - VacPak-It 186VMC16F Service Manual

Part Replacement Continued

Sealing Bar

Testing: Visually look for marks and cuts to tape on
bar
Visually ensure bar is clean of debris
Continuity between post mount locations
(Fig. 12)
Replace: if marks and cuts are found on the
if no continuity is found between
Time Estimate: Approximately 5 minutes
Part: #186PSEALBAR3 (186VMC16F ONLY)
#186P20FSB (186VMC20F ONLY)
#186P20FGFSB (186VMC20FGF ONLY)
1. Follow pre-maintenance steps from page 10
2. Lift sealing bar up from mounting tabs (Fig. 13)
3. Reverse steps to install

Lid Latch Assembly

Time Estimate: Approximately 20 minutes
Part: #186PLID20
1. Follow pre-maintenance steps from page 10
2. Remove Phillips head screws from rear panel
Note: 11 screws on 186VMC16F, 8 screws on
186VMC20F and 186VMC20FGF
3. Remove mounting bolt and nut using a Phillips head
screw driver on the outside and a 6mm socket on the
inside
4. Installation is the reverse of the removal steps
12
outside
post mount locations (Fig. 12)
Fig. 12
Fig. 13