Table of Contents
Advertisement
EMBOSSING MACHINE NOA60
To assemble the lower roller 1" 1/2 inches we will proceed as follows:
1. We put into order the different sections
3. Next we place the outer spacers 2 on the lower
shaft of the machine.
5. We remove the roller from the shaft and we
rotate it so that the front part is positioned behind
and then we put it in again.
2. We do a pre-assembly, without tightening the
bolts, paying special attention in aligning the slots
for the pin.
4. Place the pre-mounted roller on the lower axis
and tighten the bolts with the Allen key.
8
6. Tighten the bolts with the Allen key.
9
- A56 -
9
8
Advertisement
Table of Contents
