Table of Contents
Advertisement
INSTALLATION OF BATTERIES
REMOTE SENSOR:
1. Open the battery compartment located at the back of
the sensor. Remove the 2 screws on the battery cover.
2. Select the desired channel: 1, 2 or 3.
Note: If you wish to use more than one remote sensor,
each sensor must be designated a separate channel.
3. Press the ˚C/˚F button to select between Celsius (˚C) or
Fahrenheit (˚F) setting.
4. Insert 2 x AAA alkaline batteries (not included) in the
battery compartment following the polarity markings as
shown inside the compartment.
5. Close the battery cover and reattach screws.
WEAThER STATION (MAIN UNIT):
1. Open the battery compartment located at the back of
the unit.
2. Insert 2 x AA alkaline batteries (not included) in the
battery compartment following the polarity markings as
shown inside the compartment.
3. Close the battery cover.
7
7
Advertisement
Table of Contents
