Advertisement
6
model no. 040-1196-2
TOOLS REQUIRED (NOT INCLUDED)
•
1" (25 mm) adjustable wrench
•
1/2" (13 mm) socket wrench
•
15/16" (24 mm) socket wrench
•
3/4" (19 mm) socket wrench
•
3/16" (4.76 mm) hex drive screwdriver
ASSEMBLING THE BIKE CARRIER
Align the holes on the centre bracket (A) with
1
corresponding upper holes on the stinger base (B).
Secure using hex bolt (K), two flat washers (Q)
and a nylon lock nut (N) in the indicated hole.
Tighten using 15/16" (24 mm) socket wrench
and adjustable wrench.
Insert the tethered pin (23) into the aligned holes on
2
the centre bracket (A) and stinger base (B). Secure
using the pin clip (C).
Place the centre mast (E) on the centre bracket (A)
3
so that the holes on the base of the centre mast
align with the bracket.
A
N
Q
Q
K
B
A
C
23
B
E
A
Secure the centre mast (E) to the centre bracket (A)
4
using two step bolts (L), two flat washers (S), and
two nylon locknuts (O). Tighten using a 1/2" (13 mm)
socket wrench.
Place the two wheel tray load bars (D) on the centre
5
bracket (A) so that the bolt holes on the wheel tray load
bars align with the centre bracket holes.
Secure the two wheel tray load bars (D) to the
6
centre bracket (A) using four step bolts (M), four
flat washers (S) and four nylon locknuts (O). Tighten
using a 1/2" (13 mm) socket wrench.
7
E
L
A
S
O
D
A
M
D
S
O
A
Advertisement
