Central Pneumatic CONTRACTOR 92359 Set Up And Operating Instructions Manual page 9

Note: If an automatic oiler system is not
used, add a few drops of Pneumatic
Tool Oil into the tool at the airline
connection before operation. Add a
few more drops after each hour of
continual use.
2. Attach an air hose to the
compressor's air outlet. Connect the
air hose to the air inlet of the tool.
Other components, such as a coupler
plug and quick coupler, will make
operation more efficient, but are not
required. Attachment of a coiled
air hose (sold separately) will add
versatility to this tool.
WARNING! TO PREVENT SERIOUS
INJURY FROM ACCIDENTAL
OPERATION:
Do not install a female quick
coupler on the tool. Such a coupler
contains an air valve that will allow
the air tool to retain pressure and
operate accidentally after the air
supply is disconnected.
Note: Air flow, and therefore tool
performance, can be hindered by
undersized air supply components.
3. The air hose must be long enough
to reach the work area with enough
extra length to allow free movement
while working.
4. Release the tool's trigger.
5. Close the in-line safety valve between
the compressor and the tool.
6. Turn on the air compressor according
to the manufacturer's directions and
allow it to build up pressure until it
cycles off.
7. Adjust the air compressor's output
regulator so that the air output is
SKU 92359 For technical questions, please call 1-800-444-3353.
enough to properly power the tool,
but the output will not exceed the
tool's maximum air pressure at any
time. Adjust the pressure gradually,
while checking the air output gauge
for the right pressure range.
8. The air pressure setting must
not exceed job site regulations/
restrictions. The air pressure setting
must not exceed 90 PSI when being
used with work pieces that have a
thickness of less than 1-3/4".
9. Inspect the air connections for leaks.
Repair any leaks found.
10. If the tool will not be used at this time,
turn off and detach the air supply,
safely discharge any residual air
pressure, and release the trigger to
prevent accidental operation.
Note: Residual air pressure should not be
present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion
after disconnecting to ensure that the
tool is disconnected and unpowered.
Page 9