IKEA RENODLAD Manual page 48

ENGLISH
Number Setting
4 Auto door open
5 Key tones
6 Latest pro‐
gramme selec‐
tion
1) For more details, refer to the information provided in this chapter.
You can change the basic settings in setting
mode. Instructions on how to configure the
appliance are provided further in this
chapter.
When the appliance is in setting mode, the
display shows a digit and a letter. For each
setting, a dedicated letter is displayed. The
dedicated letters are indicated in the table.
The order of the basic settings presented in
the table is also the order of the settings in
setting mode.
The water softener
The water softener removes minerals from
the water supply, which would have a
negative effect on the washing results and
on the appliance.
Water hardness
German degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
Values
1o (on)
0o (off)
1F (on)
0F (off)
1H (on)
0H (off)
French degrees
(°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
Activate or deactivate the AutoOpen.
Factory setting: 1o.
Activate or deactivate the sound of the but‐
tons when pressed.
Factory setting: 1F.
Enable or disable the automatic selection of
the most recently used programme and op‐
tions.
Factory setting: 0H.
The higher the content of these minerals,
the harder your water is. Water hardness is
measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water in
your area. It is important to set the right
level of the water softener to assure good
washing results.
Softening hard water increases
the consumption of water and
energy as well as the programme
duration. The higher the level of
water softener, the higher the
consumption and the longer the
duration.
mmol/l Clarke de‐
grees
8.4 - 9.0 58 - 63
7.6 - 8.3 53 - 57
6.5 - 7.5 46 - 52
5.1 - 6.4 36 - 45
4.0 - 5.0 28 - 35
3.3 - 3.9 23 - 27
1)
Description
Water softener level
10
9
8
7
6
5
48
1)